Table of Contents
Advertisement
Imaging Mode
EI Mode Main Menu Controls
Table 7-25: EI Mode Main Menu Controls
Parameter
Scale
LVRej
Steer
Freq.
Angio
EI
Frame Rate
EI Mode Soft Menu Controls
Table 7-26: EI Mode Soft Menu Controls
Parameter
Priority
Persist
Lateral avg.
Radial avg.
Map
Power
Rev 1.00
1
Probe orientation marker 2
3
Color ROI
5
EI Mode Soft menu
Description
Adjusts the repetition rate of the Doppler pluses transmit-
ted when acquiring data for color flow mapping. The Scale
(Nyquist limit) should be adjusted so that no aliasing
occurs, while still having good resolution of velocities. The
Nyquist limit should be somewhat above the maximum
velocity found in the data.
LVR, also called Wall motion filter, adjusts the extent of low
velocity removal.
Controls the angle of the color sample volume (Only in
Liner Array Probe).
Adjusts the transmission frequency to control the sensitiv-
ity and the level of penetration. The selected frequency is
displayed in the status window. Adjusting Frequency may
affect Sample Volume and LVRej settings.
Switch to Power Mode.
Switch to 2D Mode.
Adjusts the Frame Rate.
Description
prioritize colors in Color mode.
Improve the sensitivity of the signal in time domain.
Smooths the image by averaging collected horizontal
data. Increasing lateral averaging will reduce noise, but
may also reduce lateral resolution.
Smooths the image by averaging collected radial data.
Increasing radial averaging will reduce noise, but may also
reduce radial resolution.
Displays a menu of color map options. Each color map is
assigning different color hues for different velocities.
Controls the amount of acoustic power applied in all
modes. Acoustic power cannot be set above the amount
permitted by the FDA. The Thermal index (TI) and the
Mechanical index (MI) are displayed on the screen.
Chapter 7 - System Operation
Color bar
4
EI Mode parameters window
6
EI Mode Main menu
143
Advertisement
Table of Contents
