Table of Contents
Advertisement
Imaging Mode
7.4.5
CM Mode
In CM Mode, the monitor displays a live color image about blood flow, in-
cluding the direction of blood flow and spectrum information. This function
is available only when the phased array probe is being installed.
Activate CM Mode
To activate CM Mode,
STEP
Optimize the image in CM Mode
You can optimize the image in CM Mode by adjusting any of the following
controls.
The Main Menu Controls of CM Mode
Table 7-13: The Main Menu Controls of CM Mode
Parameter
Sweep
Rev 1.00
Figure 7-26: CM Mode
Press successively 2D, CFM and M on the control panel.
Description
Adjust the horizontal refresh rate of M-Mode area display.
You can speed up or slow down the time line to observe
how often an specific event occurs.
Chapter 7 - System Operation
131
Advertisement
Table of Contents
