Table 6-2: Test Functions Defined - Teledyne 100E Instruction Manual

Model 100E Instruction Manual
Display Parameter
RANGE RANGE
- -
RANGE1
RANGE2
STABIL STABILITY
SAMPLE
PRES
PRESSURE
SAMP FL SAMPLE FLOW
PMT PMT Signal
NORM NORMALIZED
PMT PMT Signal
Source UV
UV LAMP
Lamp Intensity
LAMP UV Source
RATIO lamp ratio
STR. LGT Stray Light
DRK PMT Dark PMT
Dark UV
DRK LMP
Source Lamp
SLOPE SO
measurement
Slope
OFFSET SO
measurement
Offset
HVPS HVPS
SAMPLE
RCELL
CHAMBER
TEMP
TEMP
BOX
BOX TEMP
TEMPERATURE
PMT
PMT TEMP
TEMPERATURE
IZS
1
IZS TEMP
TEMPERATURE
2
TEST TEST SIGNAL
TIME CLOCK TIME
045150102 Rev XB1
Table 6-2:
Units
PPB, PPM,
UGM &
MGM
mV
in-Hg-A
cm³/min
(cc/m)
mV
mV
mV
%
ppb
mV
mV
-
2
-
2
V
°C
°C
°C
°C
1
2
mV
hh:mm:ss
Test Functions Defined
The Full Scale limit at which the reporting range of the
analyzer's ANALOG OUTPUTS are currently set.
THIS IS NOT the Physical Range of the instrument. See
Section 6.5 for more information.
If DUAL or AUTO Range modes have been selected, two
RANGE functions will appear, one for each range.
Standard deviation of O
are recorded every ten seconds. The calculation uses the last
25 data points.
The current pressure of the sample gas as it enters the sample
chamber, measured between the SO
The flow rate of the sample gas through the sample chamber.
This value is not measured but calculated from the sample
pressure.
The raw output voltage of the PMT.
The output voltage of the PMT after normalization for auto-zero
offset and temperature/pressure compensation (if activated).
The output voltage of the UV reference detector.
The current output of the UV reference detector divided by the
reading stored in the CPU's memory from the last time a UV
Lamp calibration was performed.
The offset due to stray light recorded by the CPU during the last
zero-point calibration performed.
The PMT output reading recorded the last time the UV source
lamp shutter was closed.
The UV reference detectort output reading recorded the last
time the UV source lamp shutter was closed.
The sensitivity of the instrument as calculated during the last
calibration activity. The slope parameter is used to set the span
calibration point of the analyzer.
The overall offset of the instrument as calculated during the last
calibration activity. The fffset parameter is used to set the zero
point of the analyzer response.
The PMT high voltage power supply.
The current temperature of the sample chamber.
The ambient temperature of the inside of the analyzer case.
The current temperature of the PMT.
The current temperature of the internal zero/span option. Only
appears when IZS option is enabled
Signal of a user-defined test function on output channel A4.
The current day time for iDAS records and calibration events.
Operating Instructions
Description
Concentration readings. Data points
3
and Auto-Zero valves.
2
57