Front Panel Interface; Analyzer Status Led's; Keyboard; Figure 10-20: M100E Front Panel Layout - Teledyne 100E Instruction Manual

Model 100E Instruction Manual

10.6.1. Front Panel Interface

FASTENER
KEY
DEFINITIONS

KEYBOARD

HINGE
The most commonly used method for communicating with the M100E UV Fluorescence
SO2 Analyzer is via the instrument's front panel which includes a set of three status
LEDs, a vacuum florescent display and a keyboard with 8 context sensitive keys.

10.6.1.1. Analyzer Status LED's

Three LEDS are used to inform the user of the instruments basic operating status
Name Color
SAMPLE Green
CAL Yellow
FAULT Red
10.6.1.2. Keyboard
A row of eight keys just below the vacuum florescent display (see Figure 10-20) is the
main method by which the user interacts with the analyzer. As the software is operated,
labels appear on the bottom row of the display directly above each active key, defining
the function of that key as it is relevant for the operation being performed. Pressing a
key causes the associated instruction to be performed by the analyzer.
Note that the keys do not auto-repeat. In circumstances where the same key must be
activated for two consecutive operations, it must be released and re-pressed.
045150102 Rev XB1
MODE FIELD
SAMPLE
< TST TST > CAL
UV FLUORESCENCE SO2 ANALYZER - MODEL 100E
ADVANCED POLLUTION INSTRUMENTATION, INC.

Figure 10-20: M100E Front Panel Layout

Table 10-2: Front Panel Status LED's

State
Off Unit is not operating in sample mode, iDAS is disabled.
On Sample Mode active; Front Panel Display being updated, iDAS data being stored.
Unit is operating in sample mode, front panel display being updated, iDAS hold-off
mode is ON, iDAS disabled
Blinking
Off Auto Cal disabled
On Auto Cal enabled
Blinking Unit is in calibration mode
Off SO warnings exist
2
Blinking Warnings exist
MESSAGE FIELD
RANGE=500.000 PPB SO2 =X.XXX
SETUP
Definition
Theory Of Operation
CONCENTRATION FIELD
FASTENER
SAMPLE
CAL
FAULT
POWER
STATUS
LED's
ON / OFF
SWITCH
191