Mitsubishi Eclipse 1990 Service Manual page 2069

Pin
Grommet
HEATER, AIR
AND VENTILATION
REMOVAL SERVICE POINT
(1) Use a Philips-head screwdriver to push inward the pin
(at the center of the clip) to a depth of about 2 mm
in.).
(2) Pull the clip outward to remove it.
Caution
Do not push the pin inward more than necessary be-
cause it may damage 'the
fall in, if pushed too far.
INSTALLATION
When replacing the cooling unit with new
rator with a specified amount of compressor oil.
Engine -(Turbo) and
Compressor oil: SUN PAG 56
Quantity: 60
Engine (Non-turbo)>
Compressor oil: ND-OIL 8
Quantity: 40
CLIP INSTALLATION
(1) With the pin pulled out, insert
(2) Push the pin inward until the pin's head
the grommet.
TSB Revision
Cooling Unit
R E M O V A L
U N I T
Engine>
(2.03
(1.35
or the pin may
refill evapo-
clip into the hole.
flush with