Table of Contents
Advertisement
HEATER, AIR
AND VENTILATION
TSB Revision
Compressor' and
Engine (Turbo) and
REMOVAL SERVICE POINTS
FLUID
Disconnect the brake fluid level sensor connector and, remove
the brake fluid reservoir from the compressor
the hose still attached.
NOTE
Place the removed brake fluid reservoir in
it will not be a hindrance when removing and installing the
A/C compressor, and tie it
COMPRESSOR DRIVE BELT REMOVAL
(1) Loosen bolt "A" for holding the tension pulley.
(2) Loosen bolt
for adjustment.
(3) Remove the compressor drive belt.
COMPRESSOR
When doing this work, be careful not to spill the compressor
oil.
INSTALLATION
COMPRESSOR INSTALLATION
If a new compressor is installed, first adjust the amount of
oil according to the procedures described below, and then
install the compressor.
Measure the amount
(1)
removed compressor.
(2) Drain (from the new compressor) the amount of oil calcu-
lated according to the following formula, and then install
then new compressor.
New compressor oil amount
170
(1)
(y
refrigerant line, the condenser, the evaporator
Pulley
cord.
(x
of oil within the
indicates the amount of oil in the
. .
where
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
