Preparing For Setup; Verifying Customer Order; Physical Inspection; Component Inspection - GE Venue R1 Service Manual

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
Section 3-4

Preparing for Setup

3-4-1

Verifying Customer Order

Compare items received by the customer to that which is listed on the delivery order. Report any items
that are missing, back ordered, or damaged.
3-4-2

Physical Inspection

Verify that the Venue™ arrived intact (visual inspection).
If the Venue™ has been damaged, please refer to
beginning of this manual.
3-4-3

Component Inspection

After verifying that all the required parts are included in the shipping crate, inspect the system components
using the checklist supplied below. In addition, ensure that all the labels described in
Introduction
label into the system installation details card, as described in
3-4-3-1 Damage Inspection Checklist
Visually inspect the contents of the shipping carton for damage. If any parts are damaged or missing,
contact an authorized GE Service Representative.
A Damage Inspection Checklist for the Venue™ ultrasound scanner is provided in
Table 3-11

3-18
6
EVISION
are present, accurate and in good condition, and enter the serial number printed on the main
Damage Inspection Checklist - Venue™ Systems
Step Item
1
Console
2
Probes
3
Cockpit (Monitor)
4
Fans
5
Rear Panel
6
Covers
7
Peripherals
8
Power Cord
9
Casters
Swivel and Full
10
Lock Castors
Section 3-3 - Receiving and Unpacking the Equipment
DAMAGE IN TRANSPORTATION
Recommended Procedure
Verify that the system is switched OFF and unplugged. Clean the console.
Check all probes for wear and tear on the lens, cable, and connector. Look for bent
or damaged pins on the connector and in the connector socket on the unit. Verify
that the EMI fingers around the probe connector socket housing are intact. Check
the probe locking mechanism and probe switch.
Clean the Cockpit (monitor) by gently wiping with a dry, soft, lint-free non-abrasive
folded cloth. Inspect the screen surface for scratches and raster burn.
Turn on the system and verify that the system's cooling fans are operating.
Check the rear panel connectors for bent pins, loose connections and loose or
missing hardware. Screw all the cable connectors tightly to the connector sockets
on the panel. Verify that the labeling is in good condition.
Check that there are no dents or scratches and that no internal parts are exposed.
Check and clean the peripherals in accordance with the manufacturer's directions.
To prevent EMI or system overheating, dress the peripheral cables inside the
peripheral cover.
Check the power cord for cuts, loose hardware, tire marks, exposed insulation, or
any deterioration. Verify continuity.
Visually check the casters for damages and for proper movement.
Check that the swivel and full lock castors can roll and swivel, and can be placed
in the locked position by pressing the foot brake (lower lever) down on each.
Ensure that the wheels are locked, unable to swivel left or right, and that there is
no movement forwards or backwards.
V
ENUE
Paperwork After Setup
™ S M
ERVICE ANUAL
on page x in the
Chapter 1 -
on page 3-57.
Table 3-11 below.