Wi-Fi Adapter Replacement/Installation Procedure - GE Venue R1 Service Manual

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
8-8-2

Wi-Fi Adapter Replacement/Installation Procedure

8-8-2-1 Tools
Appropriate Phillips screwdriver
FRU Part #
Refer to
8-8-2-2 Time Required
15 min
8-8-2-3 Preparations
1.) Shut down the Venue™ ultrasound unit, as described in
2.) Make sure the On/Off power switch is set to Off.
3.) Make sure the system is standing securely on a level surface, with the wheels in the locked position.
8-8-2-4 Wi-Fi Adapter Removal Procedure
NOTE: Perform these steps only for Venue™ systems with Wi-Fi adapter already installed on them.
For systems with no previously installed Wi-Fi adapter skip this section and proceed to section
Wi-Fi Adapter Installation Procedure (For Systems with No Existing Wi-Fi Adapter)
1.) On the back of the cockpit, release four screws and remove the transparent Wi-Fi dongle cover.
2.) Disconnect the Wi-Fi dongle.
8-170
6
EVISION
Table 9-19 .
on page 9-18
Figure 8-181 Wi-Fi Cover and Dongle Removal
Section 8-8 - Peripherals Replacement/Installation Procedures
V ™ S
ENUE
Power Shut Down .
M
ERVICE ANUAL