Electronic Boards- Replacement Procedures; Bib Board Replacement Procedure - GE Venue R1 Service Manual

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
Section 8-5

Electronic Boards- Replacement Procedures

8-5-1

BIB Board Replacement Procedure

8-5-1-1 Tools
Appropriate Phillips Screwdriver.
FRU Part #
Refer to
8-5-1-2 Time Required
15 min
8-5-1-3 Preparations
1.) Shut down the Venue™ ultrasound unit, as described in
2.) Make sure the On/Off power switch is set to Off.
3.) Make sure the system is standing securely on a level surface, with the wheels in the locked position.
8-5-1-4 BIB Board Removal Procedure
1.) Remove all accessories.
•
2.) Remove the following covers: RS Probe cover, Lower Front eTower, Left side eTower, and Right
Side eTower.
•
•
•
•
3.) Remove the Back End Module.
•
4.) Remove the supporting bracket using an appropriate Phillips screwdriver:
•
8-66
6
EVISION
Table 9-13 .
on page 9-13
Accessories - Replacement Procedures
RS Probe Cover Removal Procedure
Lower Front eTower Cover Removal Procedure
Left Side eTower Cover Removal Procedure
Right Side eTower Cover Removal Procedure
BE Module Removal Procedure
Release two captive screws
Section 8-5 - Electronic Boards- Replacement Procedures
V ™ S
ENUE
Power Shut Down .
M
ERVICE ANUAL