P R E L I M I N A R Y
D
5771498-100, R
IRECTION
3.) Attach ECG Bracket to printer bracket with 2 screws and 2 washers (verify correct orientation).
4.) Using two Thumb screws, install the bracket on the eTower.
5.) Connect the ECG USB cable to the USB 2.0 port on the BEP above the Green connector.
6.) Route the ECG USB cable through the dedicated opening in the eTower.
8-174
6
EVISION
Figure 8-186 Attaching ECG Bracket to Printer Bracket
Figure 8-187 Installing Bracket on the eTower
Figure 8-188 Connecting ECG USB Cable
Section 8-8 - Peripherals Replacement/Installation Procedures
V
™ S
M
ENUE
ERVICE
ANUAL