Riser Thermal Cover Replacement Procedure - GE Venue R1 Service Manual

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
8-3-10

Riser Thermal Cover Replacement Procedure

8-3-10-1 Tools
Appropriate Phillips screwdriver
FRU Part #
Table 9-9
Refer to
8-3-10-2 Time Required
5 min
8-3-10-3 Preparations
Shut down the Venue™ ultrasound unit, as described in
Make sure the system is standing securely on a level surface, with the wheels in the locked position.
8-3-10-4 Riser Thermal Cover Removal Procedure
1.) Remove the following covers: Lower Front eTower, Right Side and Left Side eTower covers:
•
•
•
2.) Open the door.
3.) Hold the cover and pull it down.
4.) Remove the cover.
8-3-10-5 Riser Thermal Cover Installation Procedure
Attach the Riser Thermal Cover to scanner and secure with two Phillips screws.
Perform the checks listed in
6
EVISION
.
on page 9-8
Lower Front eTower Cover Removal Procedure
Left Side eTower Cover Removal Procedure
Right Side eTower Cover Removal Procedure
Figure 8-10 Removing Riser Thermal Cover
Chapter 8 - Replacement Procedures
Riser Thermal Cover Replacement Procedure
V
ENUE
Power Shut Down .
on page 8-216
™ S M
ERVICE ANUAL
8-19