GE Venue R1 Service Manual page 250

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
8-4-2-5 Front End Metal Door Installation
1.) Install the new FE Door assembly.
2.) Install the riser thermal cover.
•
3.) Secure the Full FE Module to the FE Door with four screws (previously removed).
4.) Mount the FE Door assembly on the scanner.
5.) Reconnect the following cables:
•
•
•
6.) Close the FE door and close the two fastening latches on the left side of the Front End door
assembly.
7.) Tighten the captive screw.
8.) Refit the following covers: Mid Thermal Baffle Cover, Lower Front eTower, left side eTower, right
side eTower and RS Probe Cover.
•
•
•
•
•
9.) Install all accessories.
•
10.)Turn ON power to the system.
Perform the checks listed in
8-30
6
EVISION
Riser Thermal Cover Installation Procedure
PCIe cable
MPB TO T-FEPS Cable and secure it to the CFE module and to the T-FEPS module with cable
clips.
Fan cable
Mid Thermal Baffle Cover Installation Procedure
Left Side eTower Cover Installation Procedure
Right Side eTower Cover Installation Procedure
Lower Front eTower Cover Installation Procedure
RS Probe Cover Installation Procedure
Accessories - Replacement Procedures
Section 8-4 - System Modules- Replacement Procedures
Front End Metal Door Replacement
V ™ S
ENUE ERVICE
on page 8-216
M
ANUAL