GE Venue R1 Service Manual page 354

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
a.) On each side of each connector, use a flat screwdriver to push one of the plastic flaps towards
b.) From the front side, release both cable edges, by pulling the rubber towards you.
8-134
6
EVISION
the hole, and then push the other flap through the hole to release the connector.
Figure 8-135 Releasing the Connector
Figure 8-136 Releasing the Cable Edges
Section 8-6 - Mechanical Parts- Replacement Procedures
V ™ S M
ENUE ERVICE ANUAL