Options Setup; Software Options; Usb Flash Card Setup; Wireless Network Adapter - GE Venue R1 Service Manual

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
Section 3-9

Options Setup

3-9-1

Software Options

Most of the options for Venue™ are activated by installing a password (alphanumeric text string).
For installation instructions, see:
3-9-2

USB Flash Card Setup

There is no special setup procedure for use of a USB Flash Card.
3-9-3

Wireless Network Adapter

The Wireless Network adaptor should be connected to the USB port located on the rear side of the
cockpit (monitor).
NOTE: It is possible to connect the Wireless Network adapter both when the system is powered ON, and after
it is powered OFF.
All software drivers for the Wireless Network are pre-installed for the designated Wireless Network
adaptor only.
IMPORTANT During Stand-by mode, it is NOT recommended to introduce or remove USB
NOTICE
devices; this may cause the system to lock-up during the boot-up procedure.
DO NOT ATTEMPT TO USE A DIFFERENT TYPE OF WIRELESS NETWORK ADAPTOR.
WARNING WARNING
THE ULTRASOUND SYSTEM IS AN EXTREMELY SENSITIVE AND COMPLEX
MEDICAL SYSTEM. ANY UNAUTHORIZED PERIPHERALS MAY CAUSE SYSTEM
FAILURE OR DAMAGE!
3-52
6
EVISION
Software Options Configuration
Section 3-6 - Configuration
V ™ S
ENUE ERVICE
on page 3 - 42.
M
ANUAL