Front End Metal Door Replacement - GE Venue R1 Service Manual

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
8-4-2

Front End Metal Door Replacement

8-4-2-1 Tools
Appropriate Phillips screwdriver
FRU Part #
Table 9-7
Refer to
8-4-2-2 Time Required
5 min
8-4-2-3 Preparation
1.) Shut down the Venue™ ultrasound unit, as described in
2.) Make sure the On/Off power switch is set to Off.
3.) Make sure the system is standing securely on a level surface, with the wheels in the locked position.
8-4-2-4 Front End Metal Door Removal
1) Remove all accessories.
•
2) Remove the following covers: RS Probe Cover, Lower Front eTower, Left side eTower, Right Side
eTower, and Mid Thermal Baffle Cover.
•
•
•
•
•
3) Remove full front end.
•
4.) Remove the riser thermal cover.
•
5.) Leave the door open by approximately 30 degrees, to make enough space for the FE door to be
removed.
6
EVISION
.
on page 9-6
Accessories - Replacement Procedures
RS Probe Cover Removal Procedure
Lower Front eTower Cover Removal Procedure
Left Side eTower Cover Removal Procedure
Right Side eTower Cover Removal Procedure
Mid Thermal Baffle Cover Removal Procedure
Full Front End Removal
Riser Thermal Cover Removal Procedure
Chapter 8 - Replacement Procedures
V ™ S
ENUE
Power Shut Down .
M
ERVICE ANUAL
8-27