Mpb Module Replacement Procedure - GE Venue R1 Service Manual

P R E L I M I N A R Y
D 5771498-100, R
IRECTION
8-4-10

MPB Module Replacement Procedure

8-4-10-1 Tools
• Appropriate Phillips screwdriver.
FRU Part #
Refer to
8-4-10-2 Time Required
15 min
8-4-10-3 Preparations
1.) Shut down the Venue™ ultrasound unit, as described in
2.) Make sure the On/Off power switch is set to Off.
3.) Make sure the system is standing securely on a level surface, with the wheels in the locked position.
8-4-10-4 MPB Module Removal Procedure
1.) Remove all accessories.
•
2.) Remove the following covers: RS Probe cover, Lower Front eTower cover, Right Side eTower
cover, Left Side eTower cover and MPB Door Cover.
•
•
•
•
•
3.) Remove the Battery Packs.
•
4.) Remove the PSU module.
•
5.) Release the captive screw at the top center of the MPB.
8-56
6
EVISION
Table 9-10 .
on page 9-10
Accessories - Replacement Procedures
RS Probe Cover Removal Procedure
Lower Front eTower Cover Removal Procedure
Right Side eTower Cover Removal Procedure
Left Side eTower Cover Removal Procedure
MPB Door Cover Removal Procedure
Battery Module Removal Procedure
PSU Module Removal Procedure
Section 8-4 - System Modules- Replacement Procedures
V ™ S
ENUE
Power Shut Down .
M
ERVICE ANUAL