Table of Contents
Advertisement
2.5
Removing and installing hazard warning
light switch
The hazard warning light switch - E229- is an integral part of the
switch module in middle of dash panel and cannot be replaced
separately.
Removing and installing switch module in middle of dash panel
⇒ page 131
.
2.6
Removing and installing pushbutton for
heated rear window
The pushbutton for heated rear window - E230- is an integral part
of the switch module in middle of dash panel and cannot be re‐
placed separately.
Removing and installing switch module in middle of dash panel
⇒ page 131
.
2.7
Removing and installing seat heater
pushbutton
The pushbutton for the seat heater on the right - E654- and the
pushbutton for the seat heater on the left - E653- are integral parts
of the switch module in middle of dash panel and cannot be re‐
placed separately.
Removing and installing switch module in middle of dash panel
⇒ page 131
.
2.8
Removing and installing key-operated
switch to deactivate front passenger
side airbag
The key-operated switch for deactivating the front passenger side
airbag - E224- is located in the cover on the side of the dash panel
on the front passenger side.
WARNING
♦ Danger of the triggering of the airbag!
♦ Improper action on airbag unit may result in the triggering
of the airbag!
♦ Observe safety precautions when working on airbag.
Note
When removing and installing components that are in view
(switches, covers, trim and so on), mask off areas in which tools
( removal wedge - VAS 3409- , screwdriver) are used to lever out
those components using commercially available masking tape.
Special tools and workshop equipment required
Electrical system - Edition 03.2017
up! 2012 ➤
133
2. Controls
Advertisement
Table of Contents
