Lcd Gauge; Exhaust System - Tracker Off-Road XTR1000 Service Manual

XX238
4. Remove the cap screw and lock nut securing the shift
cable to the shift lever. Loosen the jam nut securing
the shift cable to the shift bracket. Remove the shift
cable.
XX239
INSTALLING
1. Install the new shift cable in place noting the routing
from removing. Secure to the transaxle with the
E-clip and jam nut. Finger-tighten the jam nut at this
point.
2. Install the shift cable end to the shifter bracket and
secure with the cap screw, new lock nut, and jam nut.
3. Adjust the shift cable (see ADJUSTING in this
sub-section). After cable is properly adjusted, tighten
the jam nuts to 20 ft-lb (27 N-m).
4. Install the center console, handle, rear console cover,
and both seats.
ADJUSTING
1. With the transmission in neutral, loosen the jam nut
(A) and adjust the cable until there is a small amount
of free-play in the shift lever moving forward and
backward while still in neutral.
XX240
2. Once the proper adjustment is achieved, tighten the
jam nut to 20 ft-lb (27 N-m).
 NOTE: After the jam nuts are secure, check the
shift cable again for proper adjustment.

LCD Gauge

REMOVING
1. Remove the four screws securing the gauge pod to
the steering bracket; then disconnect the gauge from
the harness. Remove the gauge pod assembly.
VOR-500
INSTALLING
1. Press the gauge into the gauge pod; then connect the
harness to the back of the gauge.
2. Secure the gauge pod assembly to the steering
bracket using the four screws. Tighten securely.

Exhaust System

REMOVING
1. Remove the rear cargo tray. Remove the three screws
securing the rear of the cargo tray heat shield to the
rear fascia heat shield.
25