Seats - Tracker Off-Road XTR1000 Service Manual

XX260
3. Connect the oxygen sensor to the main harness; then
secure the sensor wires using two push-mount cable
ties.
4. Install the rear cargo tray heat shield assembly to the
frame using the existing screws. Tighten securely.
5. Position the muffler with the manifold and secure
using the existing springs; then secure the muffler to
the transaxle bracket using the existing cap screws,
washers, and nuts. Tighten to 16 ft-lb (22 N-m).
XX259
6. Install the rear hoop frame and secure using the
existing screws and new nuts. Tighten to 35 ft-lb
(48 N-m).
7. Install the skid plate and the rear cargo tray.

Seats

REMOVING/INSTALLING DRIVER'S
SEAT
1. To remove seat, pull the seat lock lever up. Raise the
rear of the seat and tilt the seat forward.
XX066
2. To install seat, slide the front of the seat frame (B)
into the seat retainers (A) and push down firmly on
the rear of seat. The seat should automatically lock
into position.
XX067
REMOVING/INSTALLING PASSENGER
SEAT
1. To remove seat, remove two screws located near the
floor of the front of the passenger-side seat frame.
XX102
2. Pull toward the front of the vehicle on the seat back.
Pulling the seat frame clear of the pins that are on the
backside of the seat frame.
27