Tracker Off-Road XTR1000 Service Manual page 151

XX204
6. The hub and bearing housing assembly may be
removed. Doing so will prevent damage to the axle.
XX206
7. With the trailing arm still supported, remove the cap
screws securing the shock to the frame and trailing
arm. Discard the lock nuts.
XX201
XX202
150
8. Remove the cap screw securing the sway bar link to
the trailing arm.
XX208
9. Remove the cap screws securing the trailing arm to
the frame. Remove the trailing arm.
Lower
XX209
 NOTE: The drive axle does not need to be removed
for this procedure.
CLEANING AND INSPECTING
1. Clean all components.
2. Inspect the trailing arm for bends, cracks, worn bush-
ings, and worn bearings.
3. Inspect the frame mounts for signs of damage, wear,
or weldment damage.
INSTALLING
1. Apply a light amount of grease on the shock mount
sleeve and insert it into the trailing arm.
XX210