Rear Trailing Arms - Tracker Off-Road XTR1000 Service Manual

XX198
16. Using new "patch-lock" cap screws, secure the brake
caliper to the brake disc. Tighten to 35 ft-lb (48 N-m).
XX184
17. Route the brakeline hose along the upper A-arm and
secure it with the clips (B) and a cable tie (A).
Tighten the clips to 6 ft.-lb (8 N-m).
XX188
18. Install the wheels and using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb (27 N-m) incre-
ments to a final torque of 95 ft-lb (129 N-m).
19. Remove the vehicle from the support stand.

Rear Trailing Arms

REMOVING
1. Lift and support the vehicle on a support stand that
allows access to the rear suspension with the rear
tires off the floor. Remove the wheel(s).
2. Support the trailing arm at full drop height with the
shock installed.
CAUTION
Support the trailing arm to prevent it from going past
the full drop position when the axle is in place. If the
axle is in place and the trailing arm falls below full drop,
damage to the axle will occur.
XX203
3. Remove and discard the "patch-lock" cap screws
securing the brake caliper to the hub.
X199
4. Remove the cap screws securing the brakeline hose
to the trailing arm. Set the brake caliper aside.
XX200
5. Remove the locking plate and hub nut securing the
hub.
149