Tracker Off-Road XTR1000 Service Manual page 34

XX271
17. Remove the oil hose from the throttle body boot;
then loosen the clamp securing the boot from the
throttle body.
18. Remove the two screws securing the air cleaner
bracket to the throttle body. Remove the air cleaner
as an assembly.
XX283
19. Disconnect the main wiring harness from the TMAP
sensor, the coils, and the injectors; then move the
harness out of the way.
XX284
20. Drain the oil (see Engine Oil — Filter sub-section in
the Periodic Maintenance/Tune-Up section) and the
cooling system (see the Liquid Cooling System sec-
tion).
21. Remove all coolant hoses and oil hoses from the
engine.
22. Disconnect the ground cable from the engine.
XX284
23. Using a suitable support jack supporting under the
engine/transaxle assembly, remove the two cap
screws and limiter washers securing the front engine
mount to the frame.
XX286
24. Remove the four cap screws and nuts securing the
transaxle mount to the frame.
XX444
25. Remove the two clamps securing the coupler boot
around the transaxle shaft and the mid prop shaft.
33