Tracker Off-Road XTR1000 Service Manual page 54

SNO-440A
12. Align the hole (A) in the bearing with the pin (B) on
the upper crankcase; then install the crankshaft.
SNO-857
NOTE: Make sure the "Y" marks (A) on the con-

necting rods face toward the right side (MAG side) of
the crankshaft. Make sure the projection (B) faces
toward the right side (MAG side) of the crankshaft.
SNO-858
13. Seat the connecting rods to the crankshaft; then
install the connecting rod caps, new cap screws, and
new nuts. Tighten only until snug at this time.
14. Alternately tighten each of the connecting rod cap
screws evenly to 14 ft-lb (19 N-m); then put a mark
(A) on each connecting rod cap screw. Tighten the
connecting rod cap screw further to reach the speci-
fied angle (115°-125°).
SNO-859
NOTE: Rotate the crankshaft one revolution to ver-

ify free movement.
15. Using Three Bond Sealant, apply a light film of seal-
ant onto the sealing surfaces of the upper and lower
engine cases.
SNO-301
NOTE: Do not allow any sealant to come into con-

tact with the oil galley or crankshaft journal bearings.
Do not apply sealant to within 2-3 mm (0.08-0.12 in.)
of the crankshaft journal bearings.
16. Install the lower crankcase half to the upper engine
case; then verify the cases are properly seated
together.
17. Install the cap screws into the proper locations in the
crankcase; then with the torque pattern shown as
numbered on the case, tighten the cap screws only
until snug.
53