Tracker Off-Road XTR1000 Service Manual page 148

XX193
3. Account for the bushing (B) and the seals (A) on the
A-arm mount.
XX194
CLEANING AND INSPECTING
1. Clean all of the A-arm components in a parts-clean-
ing solvent.
2. Inspect the A-arms for bends, cracks, and worn bush-
ings.
3. Inspect the frame mounts for signs of damage, wear,
or weldment damage.
INSTALLING
NOTE: This process is the same for the upper and

lower A-arm.
1. To remove the bearing, remove the boot by prying on
the edge. Repeat this process on the opposite side.
XX241
2. Remove the snap ring securing the ball joint in the
A-arm. Remove ball joint.
XX191
3. Remove the bearing with a suitable press.
4. Press a new bearing into place, and secure with the
C-clip.
NOTE: Remove the ball joint only if replacement is

necessary.
5. Inspect the boot for damage. Slide the boot over the
end of the bearing.
XX195
6. Using a suitable size socket or similar tool, evenly
drive the edge of the boot into the A-arm. Repeat this
process for the opposite side.
XX192
7. Install the lower A-arm into the frame mounts and
secure it with the cap screw and new lock nut (A).
Tighten to 75 ft-lb (102 N-m).
8. Install the sway bar link to the A-arm (B). Tighten to
35 ft-lb (48 N-m).
147