Tracker Off-Road XTR1000 Service Manual page 123

TA132
REMOVING
1. Place the vehicle securely on a support stand.
2. Remove the cargo box tray, both rear wheels and
axles, the driver-side rear shock; then remove the
outer clutch cover, both clutches and the inner clutch
cover.
3. Remove the three Torx head cap screws that secure
the heat shields together under the box.
XX371
4. Remove the two Torx-head cap screws that secure
the rear fascia to the subframe.
XX372
5. While supporting the subframe, remove the two front
cap screws that secure the skid plate to the frame.
Then remove the four Allen-head cap screws (two on
each side) that secure the subframe to the frame.
122
XX373
6. Remove the four Allen-head cap screws (two on
each side) that secure the subframe to the rear sec-
tions of the frame. Remove the subframe from the
vehicle.
XX374
7. Disconnect the shift cable from the transaxle (A),
along with the shift cable bracket (C). Then discon-
nect the speed sensor (D) and gear switch (B).
Finally disconnect the vent line, located above the
gear switch (E).
XX376
8. With the transaxle supported from below, remove the
four cap screws (two on each side of the vehicle) that
secure the transaxle mount to the frame.