Tracker Off-Road XTR1000 Service Manual page 133

XX353
2. Install the intermediate shaft and idler shaft into the
case only partially. Do not seat the shafts completely
into the case at this time.
XX354
3. With the gear forks in position, install the input shaft
and reverse shaft with chain as an assembly.
XX355
 NOTE: Make sure the shift fork pins face the
installer.
 NOTE: Engage all four shafts before seating them
simultaneously into the case.
NOTE: The shift shaft rail should remain unseated

at this point.
132
XX356
4. Install the shift drum into the case; then engage the
fork tabs into the grooves in the shift drum.Pinch the
forks together and slide the rail into position in the
case.
XX357
5. Install the park pawl with dowel and spring.
XX358
TA074
6. Install the shift drum gear onto the shift drum align-
ing the appropriate splines of the drum with the gear.