Table of Contents
Advertisement
Digital Gauge
A. Seat Belt Indicator
The seat belt indicator will display each
time the ignition switch is turned ON,
and the indicator will illuminate until the
operator's seat belt is secured to remind
occupants to secure their seat belts.
! WARNING
The seat belt indicator and RPM limiter
are reminders and will turn off after the
operator's seat belt is secured. These
do not indicate that all seat belts are
properly secured. It is the operator's
responsibility to ensure all vehicle
occupants are properly seated with
seat belts secure and doors are prop-
erly latched. Serious injury or death
could occur as a result of falling out-
side a moving vehicle.
B. High Beam Indicator
The indicator is on whenever the high
beam mode is selected by the light
switch.
C. Coolant Temperature
Indicator
The indicator relates to engine coolant
temperature. The engine coolant tem-
perature indicator will display momentar-
ily each time the ignition switch is turned
ON. The indicator will illuminate if the
coolant temperature rises too far above
proper operating temperature.
NOTE: The engine RPM will be
limited with the coolant tempera-
ture indicator illuminated.
30
If the indicator is illuminated, stop the
engine immediately and allow it to cool
down. If unable to either determine or
remedy the problem, take the vehicle to
an authorized dealer for service. If not
under warranty, this service is at the dis-
cretion and expense of the vehicle
owner.
D. Malfunction Indicator
XX470
Light
A diagnostic trouble code (DTC) (see
list) will display on the digital gauge
whenever an error is detected. The code
and malfunction indicator icon will con-
tinue to be displayed on the digital gauge
until the error is corrected.
E. Coolant Temperature/
Battery Voltage/Intake Air
Temperature
This bar display shows coolant tempera-
ture, battery voltage, and intake air tem-
perature. Press the Lower Left Button to
change which parameter is being dis-
played. Press and hold the Lower Left
Button to see the actual values associated
with the mode selected.
F. Fuel Level Display
This display shows the approximate
amount of gas remaining in the gas tank.
G. RPM/Speed/Clock
Press the Upper Left Button to cycle the
left screen between RPM and speed.
NOTE: When RPM is displayed on
the left screen, the right screen will
display speed or clock. When speed
is displayed on the left screen, the
right screen will display RPM or
clock.
Press the Upper Right Button to cycle the
right screen between speed, RPM, and clock.
Press and hold the Upper Button on the
side of the digital gauge displaying speed
to shift the digital gauge between stan-
dard (mph/miles/Fahrenheit) and metric
(km/h/kilometers/Celsius) modes.
CAUTION
Advertisement
Table of Contents
