Tracker Off-Road XTR1000 Service Manual page 111

XX412
10. Inspect the seal. If the seal needs to be replaced, use
an appropriate seal removal and installation tool to
remove and replace.
XX413
11. Inspect the bearing for proper movement. If it needs
to be replaced, remove the seal and snap ring. Using
a suitable press, remove and replace the bearing.
Assembling Input Shaft
1. Side the input shaft into the housing. Secure with the
snap ring.
XX411
2. Slide the shift assembly along with the coupler into
the housing.
110
XX414
3. Place the small spring on the shaft. Using an awl or
similar tool to hold the slider shaft, install the 2 mm
Allen head cap screw. Tighten to 12 in-lb (1.4 N-m).
XX415
4. Replace the yellow plug. Tighten to 28 in-lb (3.2 N-m).
5. Place the pinion housing with new gasket onto the
differential housing; then secure with existing cap
screws. Tighten to 22 ft-lb (29.9 N-m).
XX405