Tracker Off-Road XTR1000 Service Manual page 108

XX386
9. Remove the upper differential mounting cap screw
and nut. Account for the bushings.
XX387
10. Remove the two lower differential mounting cap
screws and nuts. Account for the spacers and bush-
ings.
XX388
XX389
11. Remove the two cap screws that secure the subframe
to the front of the frame.
XX390
12. Lower the subframe and differential while moving it
forward slightly to release the rear of the subframe
from the frame.
Removing the Actuator
1. Remove the black rubber cover from the side of the
actuator.
XX400
2. Using a good quality 2 mm Allen wrench, remove
the cap screw securing the actuator to the shift pin.
NOTE: DO NOT use a ball head Allen wrench or

one that is worn. Make sure the wrench is properly
seated in the cap screw. Failure to do so will cause
damage to the cap screw and prevent removal of the
actuator.
XX401
107