Installing Engine - Tracker Off-Road XTR1000 Service Manual

XX245
26. Carefully remove the engine/transaxle assembly out
the rear of the vehicle.
27. Remove the CVT cover, drive clutch, drive belt,
driven clutch, and the inner CVT clutch cover.
28. Remove the cap screws, washers, and spacers secur-
ing the alternator guard; then loosen the cap screw
securing the alternator to the bracket. Loosen the belt
and remove the belt.
XX308
29. Remove the cap screw securing the starter motor
cable to the motor.
XX378
30. Remove the four cap screws securing the engine cra-
dle to the front of the engine.
34
VOR-515
31. Remove the two cap screws securing the rear of the
engine to the mid transaxle mount; then carefully
remove the engine free from the cradle, mount, and
the transaxle.
XX245

Installing Engine

1. Before installing the engine, be sure the starter motor
and cables are installed and secured to the engine.
XX378
2. Position the engine within the front two mounting
positions in the cradle and the two mounting loca-
tions in the mid transaxle mount. Loosely secure the
front of the engine to the cradle using the existing
cap screws.