XX071
3. Install the wiring harness connectors.
XX070B
4. Install the headlight retaining knob.
XX069A
5. Adjust the headlight using the Checking/Adjusting
Headlight Aim instructions in this section.
REMOVING TAILLIGHT/BRAKE LIGHT
NOTE: The LED taillights are not serviceable. The
entire assembly must be replaced as a component.
1. Remove the rear cargo tray.
2. Disconnect the wiring harness connector. Remove
the screws securing the taillight to the fascia.
XX073
INSTALLING TAILLIGHT/BRAKE LIGHT
1. Install screws to the fascia. Connect the wiring har-
ness connector.
XX073
CHECKING/ADJUSTING HEADLIGHT
AIM
The headlights can be adjusted vertically. The geometric
center of the HIGH beam light zone is to be used for ver-
tical aiming.
1. Position the vehicle on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).
XX029
NOTE: There should be an average operating load
on the vehicle when adjusting the headlight aim.
2. Measure the distance from the floor to the midpoint
of each headlight.
13