Tracker Off-Road XTR1000 Service Manual page 137

XX432
5. Remove the boot clamps securing the driveshaft sec-
tions. Save the clamps for installation.
XX433
NOTE: Having the transmission in neutral will aid

in rotating the driveshaft for ease of removing the
clamps.
NOTE: Using a suitable tool to break the seal of the

boot from the driveshaft will aid in removing the
driveshaft.
6. Slide the boot toward the bearing to expose the joint.
XX434
7. Remove and discard the four cap screws that secure
the coupler to the differential input.
136
XX435
8. Remove the three cap screws that secure the differ-
ential to the frame. Account for all bushings and
spacers.
XX387
XX388
XX389
9. Turn the steering wheel to the left and slide the dif-
ferential as far forward as it will go. Secure it in
place.