Headlight - Taillight - Brake Light - Tracker Off-Road XTR1000 Service Manual

XX117
3. After the lubricant has been drained, install the drain
plug and tighten to 10-22 ft-lb (14-30 N-m).
4. Add SAE-approved 80W-90 hypoid gear lube into
the fill plug hole. The lubricant level should be
approximately level with the bottom of the plug
threads.
5. Install the fill plug and tighten to 10-22 ft-lb
(14-30 N-m).
To change transaxle fluid, use the following procedure:
NOTE: The fill plug is located on the front right side

of the transaxle.
NOTE: If the fluid is contaminated with water,

inspect the drain plug, fill plug, and/or bladder.
1. Place the vehicle on level ground; then remove the
fill plug.
XX113
2. Drain the fluid into a drain pan by removing the
drain plug. Clean away any debris that may have
accumulated onto the magnetic end of the plug.
XX114
3. After the fluid has been drained, install the drain
plug and tighten to 10-22 ft-lb (14-30 N-m).
4. Add Synthetic Transaxle Fluid with EP into the fill
plug hole. The fluid level should be approximately
level with the bottom of the plug threads.
5. Install the fill plug and tighten to 10-22 ft-lb (14-30 N-m).
Headlight —
Taillight — Brake Light
HEADLIGHT BULB REPLACEMENT
NOTE: The LED strips in the headlight assembly

are not individually replaceable. The entire assembly
must be replaced as a component.
1. Remove hood
2. Remove the wiring harness connector (A) from the
back of the headlight bulb (B).
3. Rotate the headlight bulb (B) counterclockwise to
remove from the assembly.
XX069
4. Rotate the new headlight bulb (B) clockwise into
headlight assembly. Reinstall wiring harness connec-
tor (A).
5. Adjust the headlight using the Checking/Adjusting
Headlight Aim instructions in this section.
11