Steering/Body/Controls; Hood/Rear Cargo Tray/Grille - Tracker Off-Road XTR1000 Service Manual

Steering/Body/Controls

The following steering components should be inspected
periodically to ensure safe and proper operation:
A. Steering wheel secure.
B. Steering has equal and complete full-left and
full-right turning capability.
C. Steering sector mounting bolts tight.
D. Ball joints not worn, cracked, or damaged.
E. Tie rods not bent or cracked.
F. Knuckles not worn, cracked, or damaged.
G. Cotter pins not damaged or missing.
H. Steering wheel tilt locks securely.
The frame and welds should be checked periodically for
damage, bends, cracks, deterioration, broken compo-
nents, and missing components.
Hood/Rear Cargo
Tray/Grille
REMOVING/INSTALLING HOOD
1. Turn the two 1/4-turn fasteners counterclockwise and
remove hood.
VOR-471
2. Insert the tabs on the rear of hood into the rear por-
tion of the front body panels. Lay the hood down flat.
Turn both of the fasteners clockwise securing the
hood.
REMOVING/INSTALLING REAR CARGO
TRAY
1. Remove fasteners from the rear cargo tray by turning
counterclockwise
VOR-474
2. Remove rear cargo tray by lifting vertically.
3. Rear cargo tray is directional. Install the rear cargo
tray.
4. Secure with fasteners by turning clockwise. Tighten
fasteners securely
REMOVING GRILLE
1. Remove hood.
2. Remove fasteners securing lower fascia. Remove
lower fascia.
VOR-472
3. Remove the fasteners securing the grille.
VOR-473
4. Remove grille by slightly lifting fenders while care-
fully sliding grille downward.
17