Tracker Off-Road XTR1000 Service Manual page 42

SNO-753
 NOTE: The engine may have to be rotated for the
water pump gear to clear the counterbalancer.
13. Disconnect all hoses from the oil cooler; then
remove the Allen-head screws securing the oil cooler
assembly to the engine. Remove the assembly.
VOR-521
14. Remove the two Allen-head screws securing the
chain tensioner to the cylinder assembly. Remove the
tensioner and gasket.
15. Remove the cap screws securing the exhaust cam-
shaft cap (A), intake camshaft cap (B), and the cam-
shaft (C). Account for the dowel pins that may still
be connected to the camshaft caps.
NOTE: To prevent damage to the cylinder head,

camshafts, or camshaft caps, loosen the camshaft cap
screws in stages and in a crisscross pattern working
from the outside in.
SNO-756
16. Remove the exhaust and intake camshafts from the
engine.
SNO-757
17. Remove the eight cap screws (#3-10) and two
Allen-head screws (#1 and #2). Remove the head
and account for the gasket and dowel pins.
 NOTE: Loosen the cap screws in the proper
sequence as shown. Loosen each cap screw 1/2 of a
turn at a time. After all of the cap screws are fully
loosened, remove them.
SNO-758
18. Remove the cap screws securing the timing chain
tension guides to the engine; then remove the guides.
41