Lights - Tracker Off-Road XTR1000 Service Manual

VOLTAGE
1. Locate the 4-wire connector for the front drive actua-
tor above the differential; then connect the red meter
lead to the orange wire using a MaxiClip.
2. Connect the black tester lead to the black wire using a
MaxiClip; then select 2WD on the drive select switch.
 NOTE: The black tester lead can remain connected
to the black wire for the remaining tests.
3. Turn the ignition switch to the ON position. The
meter must show battery voltage.
NOTE: If battery voltage is not shown, troubleshoot

the fuses in the power distribution module, the igni-
tion switch, or the main wiring harness.
4. Connect the red meter lead to the white/green wire.
The meter must show battery voltage.
5. Select 4WD on the drive select switch. The meter
must show 0 DC volts.
6. Connect the red meter lead to the white/orange wire.
The meter must show battery voltage.
7. Select LOCK on the drive select switch. The meter
must show 0 DC volts.

Lights

Each headlight has two connectors. one HI/LO (Head-
lights) three-pin connector and one accent light two-wire
connector.
VOLTAGE (Headlights)
 NOTE: The HI/LO bulb-connector uses a three-pin
connector with the corresponding color codes: white,
yellow/black, and black.
1. Behind the headlight remove the inner most connec-
tor from the headlight; then set the meter selector to
the DC Voltage position.
XX333
84
XX334
2. Connect the black meter lead to the black wire (B);
then connect the red meter lead to the white wire (C);
then turn the key switch to the on position and turn
the light switch to low beam. Voltage must be pres-
ent. If no voltage is present, troubleshoot the
LO-BEAM fuse, or lights switch.
3. Connect the black meter lead to the black wire (B);
then the red meter lead to the yellow/black wire (A);
then turn the key switch to the on position and turn
the light switch to the high beam. Voltage must be
present. If no voltage is present, troubleshoot the
HI-BEAM fuse, or lights switch.
 NOTE: If both high beam and low beam have no
voltage, check the lights relay, main fuse, lights
switch, battery connections, or wiring harness.
VOLTAGE (Accents)
NOTE: The Accent connector uses two-wires in a

three-pin connector with the corresponding color
codes: white/red, and black.
1. Behind the headlight remove the outer most connec-
tor from the headlight; then set the meter selector to
the DC Voltage position.
XX335