Table of Contents
Advertisement
! WARNING
Leaving the fuel valve in the ON or
RES position when the engine is off
can be hazardous. The carburetor may
overflow and fuel may run into the
engine. This can cause a fire or cause
severe damage to the ATV when the
engine is started. Always leave the
fuel valve in the OFF position when
the engine is not running.
Speedometer/LCD/
Indicator Lights
1. Mode/Set Button — In conjunction
with Mode/Set Button (2), shifts the
LCD through mode and reset opera-
tions.
2. Mode/Set Button — In conjunction
with Mode/Set Button (1), shifts the
LCD through mode and reset opera-
tions.
3. Coolant Temperature Indicator —
Displays approximate engine cool-
ant temperature.
NOTE: Normal operating range is
from the bottom segment (C) up to
but not including the top segment
(H). In the event the top segment (H)
is displayed, all segments of the dis-
play and the temperature icon will
flash indicating high engine tem-
perature. For more information, see
Cooling System.
4. Speedometer — Displays approxi-
mate vehicle speed in mph or km/h.
NOTE:
between mph and km/h, press the
Mode/Set Button for two seconds.
The LCD will display either mph or
km/h on the right-side of the display.
The Odometer/Trip Meter (7) will shift
to
correspond
with the speedometer.
5. Fuel Level Indicator — Indicates
approximate amount of gasoline in
the gas tank.
NOTE: When the bottom segment
flashes, gasoline quantity is low.
6. Digital Clock — Displays time in
hours and minutes when the ignition
switch is turned to the ON position.
To set the time, turn the ignition
switch to the ON position; then use
the following procedure.
NOTE: If the Hour Set or Minute
Set operation is interrupted for more
than 10 seconds, the clock will
KM123E
return to normal operation.
A. Hour Set: Press and hold Mode/
Set Buttons (1) and (2) until the
hour display flashes; then release
both buttons and again press
Mode/Set Button (2) to select the
desired hour. When the desired
hour is displayed, release the
button.
NOTE:
sequential 24-hour time only. There
is no 12-hour AM/PM designation.
B. Minute Set: Press and hold
Mode/Set Button (1) until the
minute display flashes; then
release the button and press
Mode/Set Button (2) to select the
desired
desired minute is displayed,
release the button.
NOTE: When the button is released
for more than 10 seconds, the clock
will return to normal operation.
To
shift
the
(miles/kilometers)
The
clock
displays
minute.
When
display
a
the
43
Hide quick links:
Advertisement
Table of Contents
