Tracker Off-Road XTR1000 Service Manual page 138

XX436
 NOTE: The cap screws that secure the front of the
subframe to the frame can be removed to allow the
front of the subframe to be lowered for more room.
See the differential removal section.
XX390
10. Carefully work the two driveshaft sections apart.
XX437
11. Remove the clamp securing the coupler to the drive
shaft. Remove the coupler. Account for the spacer.
Save the clamp for installation.
XX438
12. Remove the axle from the vehicle through the driver
side of the cockpit.
NOTE: At this point, no further disassembling is

required to replace the driveshaft. If the technician's
objective is to replace the carrier bearing, proceed to
step 13.
NOTE: The carrier bearing is a non-serviceable

item. It must be replaced as an assembly.
13. Loosen the two set screws on the bearing but do not
remove them.
XX439
14. Remove the snap ring.
XX440
15. Slide the carrier bearing assembly off the shaft.
NOTE: It may be necessary to lightly tap the carrier

bearing with a rubber mallet to aid in removing it.
137