Tracker Off-Road XTR1000 Service Manual page 40

VOR-518
3. Remove plastic plug (A) from the MAG cover.
VOR-517
NOTE: The engine cylinders are numbered #1, #2,

and #3 from the PTO to the MAG.
SNO-318A
4. Obtain top-dead-center (TDC) by rotating the crank-
shaft (clockwise) until the mark (A) on the magneto
rotor is aligned with the pointer on the magneto
cover (B) and the #3 piston is at TDC using the cap
screw that secures the pulley to the end of the crank-
shaft.
SNO-279A
NOTE: TDC on the compression stroke can be

found when the camshaft lobes for cylinder #3 (MAG
side) are turned away from each other.
NOTE: At this point, if the technician's objective is

to service the valves, proceed to Servicing Compo-
nents — Valves in this sub-section.
5. Remove the two cap screws securing the starter
motor assembly to the crankcase; then remove the
starter motor.
SNO-730
6. Loosen the cap screw that is securing the alternator
output assembly to the crankshaft until access to the
screw-in lip seal is achieved; then using a 41 mm
crowfoot wrench, remove the lip seal from the mag-
neto cover. Remove the entire assembly from the
engine.
XX315
7. Remove the Allen-head screws securing the MAG
cover to the crankcase.
39