Preparation After Storage - Tracker Off-Road XTR1000 Service Manual

Preparation after Storage

Taking this vehicle out of storage and correctly preparing
it will ensure many miles and hours of trouble-free rid-
ing. The manufacturer recommends the following proce-
dure:
1. Clean the vehicle thoroughly.
2. Clean the engine. Remove the cloth from the exhaust
system.
3. Check all control wires and cables for signs of wear
or fraying. Replace if necessary.
4. Change the engine oil and filter.
5. Check the coolant level and add properly mixed
coolant as necessary.
6. Charge the battery; then install. Connect the battery
cables making sure to connect the positive cable
first.
6
CAUTION
Before installing the battery, make sure the ignition
switch is in the OFF position.
7. Check the entire brake systems (fluid level, pads,
etc.), all controls, headlights, taillight, brake light,
and headlight aim; adjust or replace if necessary.
8. Check the tire pressure. Inflate to recommended
pressure as necessary.
9. Tighten all nuts, bolts, cap screws, and screws mak-
ing sure all calibrated nuts, cap screws, and bolts are
tightened to specifications.
10. Make sure the steering moves freely and does not
bind.
11. Check the spark plugs. Clean or replace as necessary.
12. Check the air filter and the air filter housing. Clean
or replace as necessary.