Accessory Receptacle/Connector; Switches - Tracker Off-Road XTR1000 Service Manual

SNO-655
3. Connect the red meter lead to one of the terminals;
then connect the black meter lead to the bottom of
the coil. Secondary coil resistance must be
8500-11500 ohms.
SNO-656
4. Repeat the test on the other two ignition coils.
 NOTE: If resistance is not within specification, the
coil must be replaced.
Accessory
Receptacle/Connector
 NOTE: This test procedure is for either the recepta-
cles or the connectors.
VOLTAGE (Switched)
1. Turn the ignition switch to the ON position; then set
the meter selector to the DC Voltage position.
NOTE: There are three black terminals and 3

orange/black terminals that are connected to their
respective colors.
2. Connect the red tester lead to the orange/black wire;
then connect the black tester lead to ground.
3. The meter must show battery voltage.
NOTE: If the meter shows no battery voltage, trou-

bleshoot the battery, SW. ACC fuse, SW. ACC relay,
receptacle, connector, or the main wiring harness.
VOLTAGE (Constant)
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to the red/white wire;
then connect the black tester lead to ground.
3. The meter must show battery voltage.
NOTE: If the meter shows no battery voltage, trou-

bleshoot the battery, fuse, receptacle, connector, or
the main wiring harness.

Switches

SEAT BELT LIMITER
 NOTE: This vehicle is equipped with a speed limita-
tion device to limit the speed if the operator's seat belt
is not fully engaged. The seat belt indicator light will
remain illuminated until the operator's seat belt is
fully engaged.
Resistance
1. Set the meter to the OHMS position.
2. Remove the driver's seat. Locate the switch connec-
tor; then disconnect the connector.
XX330
3. Buckle the driver's seat belt. On the switch side of
the connector, connect one meter lead to one pin and
the other meter lead to the opposite connector pin.
MOD485
4. Meter reading should show less than one ohm.
5. Release the seat belt latch from the buckle, with the
meter leads still connected to the pins. Meter reading
should show OL.
81