Tracker Off-Road XTR1000 Service Manual page 41

SNO-752
8. Thread the MAG Cover Removal Cap Screw into the
timing mark hole; then carefully pull the MAG cover
from the crankcase. Account for two dowel pins and
a gasket.
YM-203
! WARNING
When removing the cover be sure to keep hands away
from being pinched between the cover and the case.
YM-204
9. Remove the starter gear and shaft.
40
YM-205
10. Using Flywheel Puller, remove the flywheel from the
crankshaft. Account for the key in the crankshaft.
YM-206
YM-207
11. Thread the primary sheave bolt into the end of the
crankshaft and pull the output shaft assembly from
the engine.
12. Remove the Allen-head screws securing the water
pump assembly to the crankcase; then remove the
assembly. Account for two dowel pins and two gas-
kets.