Tracker Off-Road XTR1000 Service Manual page 127

XX307
2. Inspect the gear teeth for nicks, cracks, chips, or
signs of wear. If any are present, the gear must be
replaced.
B. Intermediate Shaft
1. Inspect the bearing for free and smooth turning. If
the bearing does not turn freely, it must be replaced.
TA035
2. Inspect the gear teeth for nicks, cracks, chips, or
signs of wear. If any are present, the gear must be
replaced.
TA036
3. Inspect the shaft gear teeth for nicks, cracks, chips,
or signs of wear. If any are present, the shaft must be
replaced.
C. Shift Shaft Rail
1. Inspect the shift forks for nicks, cracks, chips, or
signs of wear. If any are present, the forks must be
replaced.
126
TA041
2. Inspect the rail for nicks, cracks, chips, or signs of
wear. If any are present, the rail must be replaced.
D. Shift Shaft
Inspect the gear for nicks, cracks, chips, or signs of wear.
If any are present, the gear must be replaced.
E. Idler Shaft
1. Inspect the bearings for free and smooth turning. If
either bearing does not turn freely, it must be
replaced.
TA033
2. Inspect the gear teeth for nicks, cracks, chips, or
signs of wear. If any are present, the gear must be
replaced.
TA034
3. Inspect the shaft gear teeth for nicks, cracks, chips,
or signs of wear. If any are present, the shaft must be
replaced.
F. Shift Drum
1. Remove the snap ring and washer; then pull the cam
off the shift drum.