Driveshaft/Carrier Bearing - Tracker Off-Road XTR1000 Service Manual

XX374
7. Using new lock nuts, secure the subframe to the
frame with the four Allen head cap screws (two on
each side). Tighten to 35 ft-lb (47.6 N-m). Secure the
front of the skid plate to the frame. Tighten to 8 ft-lb
10.9 N-m).
XX373
8. Secure the rear fascia to the subframe. Tighten to 4
ft-lb (5.4 N-m).
XX372
9. Install the three Torx-head cap screws that secure the
heat shields together under the box. Tighten to 4 ft-lb
(5.4 N-m).
XX371
10. Install the cargo box tray, both rear wheels and axles,
driver-side rear shock, inner clutch cover, both
clutches and the outer clutch cover.
11. Remove from the vehicle from the support stand.

Driveshaft/Carrier Bearing

 NOTE: This process can also be used to remove the
driveshaft coupler.
REMOVING
1. Remove the seats, battery cover, and center console.
2. Secure the vehicle on a support stand to elevate the
wheels; then remove the front left wheel.
3. Remove the three cap screws and the shift linkage
that holds the shifter support bracket to the frame.
Discard the lock nut.
XX431
4. Remove the cap screw that secure the carrier bearing
bracket to the frame.
135