XX402
3. Remove the three Torx T-30 cap screws that hold the
actuator to the differential. Two are on the side (A)
and one is behind the actuator (B).
XX403
4. Carefully slide the actuator off the differential.
NOTE: The actuator has no serviceable parts on the
inside and must be replaced as an entire unit.
XX404
Installing the Actuator
1. Carefully slide the actuator over the shift shaft. A
needle nose pliers or similar tool may be needed to
hold the shaft in place. Take care not to damage the
shift shaft.
108
XX427
2. Make sure the shift shaft is properly lined up when
the actuator is fully seated.
XX428
3. Install the 2 mm Allen-head cap screw. Tighten to
12 in-lb (1.4 N-m).
XX402
4. Install the three cap screws that secure the actuator to
the differential. Tighten to 10 ft-lb (13.6 N-m).
XX403