Tracker Off-Road XTR1000 Service Manual page 141

WS097
 NOTE: If the brake pads are to be returned to ser-
vice, do not allow brake fluid to contaminate them.
WS098
6. Remove the caliper holder from the caliper.
WS099
7. Remove the caliper holder boots.
WS103
NOTE: Remove the caliper holder boots only if they

are going to be replaced.
140
CLEANING AND INSPECTING
1. Clean all caliper components (except the brake pads)
with DOT 4 brake fluid. Do not wipe dry.
2. Inspect the brake pads for damage and excessive
wear.
 NOTE: For measuring brake pads, see Periodic
Maintenance/Tune-Up.
3. Inspect the brake caliper housings for signs of corro-
sion or damage.
4. Inspect the caliper holder for wear or bending.
ASSEMBLING/INSTALLING
1. Apply high-temperature silicone grease to the inside
of the caliper holder bores.
WS105A
2. Install the caliper holder boots making sure they are
seated properly.
WS096
NOTE: The shorter of the two caliper boots is on the

side of the jam screw.
3. Install the caliper onto the caliper holder.