Tracker Off-Road XTR1000 Service Manual page 105

XX386
9. Remove the upper differential mounting cap screw
and nut. Account for the bushings.
XX387
10. Remove the two lower differential mounting cap
screws and nuts. Account for the spacers and bush-
ings.
XX388
XX389
11. Remove the two cap screws that secure the subframe
to the front of the frame.
104
XX390
12. Lower the subframe and differential while moving
them forward slightly to release the rear of the sub-
frame from the frame.
XX392
13. Lower the subframe until there is enough clearance
to remove the coupler. Do not lower any more than
needed.
14. Remove the clamp for the boot; then the coupler.
Inspect the boot for damage. Replace if necessary.
XX393
INSTALLING
1. Clean and inspect the splines on the driveshaft.
2. Put a small amount of molybdenum grease on the
driveshaft splines.
3. Install a new coupler onto the driveshaft and secure
the boot to the coupler using a new clamp.
4. Lift the differential/subframe into place, making sure
the rear of the subframe falls into its proper location.
Thread the two front cap screw into place but leave
loose.