Tracker Off-Road XTR1000 Service Manual page 37

XX245
11. Secure the ground cable to the magneto cover using
the existing screw. Tighten to 8 ft-lb (10.9 N-m).
XX284
12. Connect all oil and coolant hoses to the engine.
Secure using the existing clamps.
13. Install the intake manifold assembly to the engine
using the existing clamps. Tighten to 30 in.-lb
(3.4 N-m).
XX379
14. Secure the intake manifold to the engine cradle using
the existing nuts. Tighten to 10 ft-lb (13.6 N-m).
36
XX380
15. Connect the main wiring harness to the TMAP sen-
sor, the coils, and the injectors. Press the white push
mounts into the injector rail. Cable tie wires as
needed.
XX284
16. Position the air cleaner bracket onto the intake mani-
fold. Secure using the two screws (threads coated
with blue Loctite #243). Tighten to 8 ft-lb
(10.9 N-m).
17. Install the oil separator vent line to the fitting on the
throttle body boot, secure using the clamp; then
secure the throttle body boot to the intake manifold
using the existing clamp. Tighten securely.
XX283
18. With the gaskets positioned on the engine and on the
transaxle, secure the inner CVT cover to the engine
and the transaxle using the existing screws. Tighten
to 8 ft-lb (10.9 N-m) using a crisscross pattern.