Tracker Off-Road XTR1000 Service Manual page 119

XX186A
CAUTION
Support the knuckle when removing the cap screw to
prevent damage.
7. Secure the upper A-arm up and out of the way.
8. Rotate the knuckle down while simultaneously push-
ing the axle out of the hub.
XX394
9. Pushing the axle shaft in, pull the axle assembly
from the differential. Account for the rubber O-ring.
CF633A
INSTALLING FRONT DRIVE AXLE
1. Install the axle into the front differential.
2. With the axle going through the center of the
knuckle, rotate it upward and secure the upper A-arm
to the knuckle using a new "patch-lock" cap screw.
Tighten to 75 ft-lb (102 N-m).
118
XX197
3. Install the tie rod end using a new cap screw. Tighten
to 42 ft-lb (57.1 N-m).
XX185
4. Install the hub and axle nut. Apply red Loctite #271
to the axle nut and tighten to 250 lb-ft (339 N-m).
Continue to tighten until the locking plate fits over
the nut.
XX198
5. Using new "patch-lock" cap screws, secure the brake
caliper to the brake disc. Tighten to 35 ft-lb
(47.6 N-m).