Table of Contents
Advertisement
XX150A
4. Firmly grasp the inner cup and pull the axle from
the transaxle.
XX151A
5. Support the swing arm by a hydraulic jack or simi-
lar tool. Disconnect the sway bar and upper shock
mount. This will allow the swing arm to move
down, allowing space to remove the axle from the
vehicle.
XX152A
116
XX160A
6. Compress the inner CV joint and move it to the
shown position.
XX154A
7. With the cup still compressed, lower the swing
arm while simultaneously moving the axle out of
the chassis.
INSTALLING REAR DRIVE AXLE
1. To install, reverse the steps used to remove the
axle.
! WARNING
Note the location of the plunger prior to installing the
axle.
! WARNING
When the axle is in place, do not allow the swing arm to
move down more than is needed to install the axle. Mov-
ing the swing arm down too far will overextend the outer
CV joint. This may cause the CV joint to come apart.
XX161A
Advertisement
Table of Contents
Troubleshooting
